The D.A.S. ST-32 is a compact high efficiency two way vented stage monitor and multi - purpose system.
The system is made up of a cone speaker and a compression driver mounted coaxially. A 15” speaker with a 4” voice coil is used for the low end, while the high frequencies are handled by a 2” exit compression driver with a 4” titanium diaphragm and voice coil, coupled to a integral conical horn. The use of large magnetic circuitries and voice coils assures high resistance to abuse
The coaxial arrangement of the low and high frequency drivers results in a directivity response free of irregularities, which helps overcoming microphone feedback problems. The front baffle is angled 35˚, which is adequate for typical stage monitoring situations.
The enclosure is manufactured from Wisa® Birch plywood and is finished with a durable catalyzed polyurethane paint that provides protection against the elements and abrasion. The wedge shape minimizes panel vibration and cabinet modes.
The ST-32 has a polyamide powder coated steel grille to protect the loudspeaker components. The grille is covered with a fabric that provides resistance to wear and tear, protection from dust and dirt, and is both acoustically transparent and flame retardant. An integral 35mm socket can be used for tripod mounting, extending the range of applications for the system.
RMS (Average) Power Handling: 300 W
Program Power Handling: 600 W
Peak Power Handling: 1200 W
On-axis Frequency Range: 60Hz - 20KHz
Nominal Impedance: 8 Ω
Minimum Impedance: 6 Ω (at 65Hz)
On-axis Sensitivity 1W / 1m: 98 db SPL
Rated Peak SPL at Full Power: 129 db
Nominal -6 db Beamwidths: 85˚ Horizontal
(average, 500Hz to 8KHz) 85˚ Vertical
Speech Coverage Angles: 85˚ Horizontal x 85˚ Vertical
Enclosure Material: Wisa® Birch Plywood
Finish: Durable Catalyzed Polyurethane Paint
Transducers / Replacements Parts: CX-32/ GM B-30 (low), GM M-8 (high)
Connector: 2 paralleled NL4 Speakon, wired to 1 hot / neg.
Dimensions (H x W X D): 45 x 54 x 62 cm (18 x 21.5 x 24.5 in)
Weight: 57.2 lbs
Shipping Weight: 63.8 lbs
Crest Audio CA 9
• 8 Ohm Stereo - 600 W
• 4 Ohm Stereo - 900 W
• 2 Ohm Stereo - 1000 W
• 8 Ohm Bridged - 1800 W
• 4 Ohm Bridged - 2000 W
• Legendary over-built power supply
• Toroidal power transformer
• Latest generation of high-speed, wide-bandwidth output devices
• Twin-tunnel cooling with back-to-front air flow
• Dual, rear-mounted, continuously variable-speed fans
• Balanced male and female XLR inputs with switch-configurable XLR polarity and sensitivity selection
• Speakon® or five-way binding post output connectors (market dependent)
• Stereo, parallel, bridged-mono mode selector switch
• Ground-lift switch
• Front panel circuit-breaker switch
• Recessed, stepped attenuators
• SIGNAL present/active, PROTECT, and ACL LED's
• Modular construction
• Powder-coated steel chassis
Dimensions 19" W x 3.5" H x 18" D
(483 mm x 89 mm x 458 mm)
Weight 47 lbs. (22 kg)
